The things should be noted when using calcium carbonate grinding millPosted: 2018-12-07

  • Clirik calcium carbonate grinding mill also named HGM micro powder grinding mill.

    calcium carbonate grinding mill.jpg

    It is suitable for processing non-inflammable,non-explosive and brittle materials with Moh's hardness under 6,such as calcite,chalk,limestone,marble,dolomite,kaolin,bentonite,talc,mica,magnesite,illite,pyrophyllite and vermiculite,sepiolite,attapulgite,rectorite,barite,gypsum,alunite,graphite,fluorite,rockphosphate,kaliium ore,pumice,fly ash,etc.

    Finial Powder Fineness Range:from 325 mesh to 2500 mesh.So it also be called ultra fine grinding mill

    calcium carbonate grinding machine.jpg

    The technicians of Shanghai Clirik Machinery Co., Ltd. specially reminded you when using calcium carbonate grinding mill:

    1. The humidity of the material, that is, the moisture contained in the material is large, the material is easy to adhere in the mill, and it is easy to block during the feeding process, resulting in a reduction in the capacity of the calcium carbonate grinding machine.

    2. The fineness requirements are high, that is, the finer the material that is required to be ground by the grinding mill, the smaller the output of the calcium carbonate grinding mill.

    3. The composition of the material, the more fine powder contained in the material before the mill, the more impact the calcium carbonate grinding machine, because these fine powder is easy to adhere to affect the transport. For the content of fine powder, it should be sieved once in advance.

    4. The viscosity of the material. That is, the greater the viscosity of the material, the easier it is to adhere.

    5. The wear resistance of the grinding parts of calcium carbonate processing equipment is better, the greater the capacity of the grinding machine, if it is not wear-resistant, it will affect the capacity of the grinding machine.

    6. For the calcium carbonate grinding mill from the factory to the use time of more than 6 months, the main shaft system, transmission, grinding roller device and analytical oil pool should be cleaned and inspected. After the cleaning inspection, sufficient lubricant should be added to each component. .

     

    The calcium carbonate processing equipment of Shanghai Clirik Machinery Co., Ltd. is widely used in the grinding of mineral materials in the fields of metallurgy, building materials, chemicals and mining.
    Suitable for processing non-flammable and explosive minerals with a Mohs hardness of less than seven grades and a humidity below 6%, such as gypsum, talc, calcite, limestone, marble, potash feldspar, barite, dolomite, granite, kaolin, Bentonite, medical stone, bauxite, iron oxide red, iron ore, etc.
    The fineness of the finished product is between 325-2500 mesh.

    Through the joint action of the analysis machine and the fan, it can meet the requirements of different users.
    Welcome to come to consult and purchase!

    More about calcium carbonate processing equipment:https://www.calciumcarbonategrinding.com/products/

Previous:A Glimpse Of Bauma China 2018
Next:Back

Feedback

Feedback

Recommend

Calcium Carbonate Grinding Mill

Capacity:0.4-30 T/H
Feeding size:≤20mm
Output Size:150-3000mesh
Calcium Carbonate Grinding Mill is the equipment specializing in producing fine and superfine calcium carbonate powder

    Contact us

  • Office Address: No.19Fuqing Rd,Shanghai
  • E-mail: Sales@clirik.com

  • Sales Department Tel :0086-21-20236178

Copyright 2014 by Shanghai Clirik Machinery Co. LTD All rights reservedE-mail:sales@clirik.com